You have no items in your shopping cart.



Profile Informations

Login Datas

or login

First name is required!
Last name is required!
First name is not valid!
Last name is not valid!
This is not an email address!
Email address is required!
This email is already registered!
Password is required!
Enter a valid password!
Please enter 6 or more characters!
Please enter 16 or less characters!
Passwords are not same!
Terms and Conditions are required!
Email or Password is wrong!
Captcha is required!
Captcha is wrong!

IBOX Upgrade Guide (PhoenixSuit tool)

1. Download the firmware and upgrade tool

1.1 Download the firmware package and PhoenixSuit upgrade tool.

1.2 Save them to local disk in PC.

2. Install the upgrade tools

2.1 Install  PhoenixSuit V1.0.6

Double-click  to run PhoenixSuit software installation wizard. Follow the installation wizard to install the software upgrade tool.

Click Next as shown below:

Select installation folder as shown below:

Confirm installation as shown below:

Installing PhoenixSuit as shown below:

 NOTE: During the installation process, it may require to install the driver as shown in the following picture, just select "下一步"(means Next) to install the driver as shown below:

The drivers were successfully installed on this computer as shown below. Then click '完成'(means Finish).

PhoenixSuit has been successfully installed as shown below, click "Close".

2.2 Upgrade to V1.08

When you open PhoenixSuit V1.0.6, there will be a pop-up dialogue box as shown below, click "Yes" to upgrade to V1.08 and follow the steps below.

Do not click Cancel during upgrade, otherwise it will fail.

Upgrading complete, click "Finish".

Then it will require to install the device driver as shown below, click "Next".

Do not click Cancel during upgrade, otherwise it will fail.

Device driver has been successfully installed, click "Finish". 

3. Upgrade

1) Click the icon   to open the upgrade tool .
Tool page is shown as below:
2) Click the button  to enter upgrade mode. Click button , select the firmware package, and click " Open ."
3) After selecting the firmware package, connect one end of the standard USB cable to PC, and then perform the following operations:
Press the uboot button then, while keeping the button pressed, connect the USB cable into the USB4 port on the IBOX.
4) Select the upgrade mode in the dialog box, as shown below:
If you select "Yes" to upgrade via formatting, it will clear all user data. If you select "No" to upgrade in common mode, it will retain user data.
Recommendation: Back up all data, select "Yes" to upgrade via formatting to avoid error in some program or data after upgrading.

5) After the programming is completed, press "OK" to complete the upgrade.

Note: Do not unplug the equipment during upgrading to avoid damage to the equipment!