Loading...

You have no items in your shopping cart.

 
 
 
×

Registration

Profile Informations

Login Datas

or login

First name is required!
Last name is required!
First name is not valid!
Last name is not valid!
This is not an email address!
Email address is required!
This email is already registered!
Password is required!
Enter a valid password!
Please enter 6 or more characters!
Please enter 16 or less characters!
Passwords are not same!
Terms and Conditions are required!
Email or Password is wrong!
Captcha is required!
Captcha is wrong!

Sniffer Nano Firmware v1.1 AND Door Controller

The Sniffer Nano Firmware is update to v1.1, and it’s patched by Flemming Frandsen.

Flemming Frandsen is a Danish designer who bought our product, he found that the Sniffer Nano source code is not easy to read and written in a completely different style than what he was used to, so this guy do a great job to modify the code and make some significant improvement:
  • Cleaned up the code a bit
  • Converted to using a bit array to save 7/8 of the RAM

Download the Source code here:

  SnifferNano Firmware v1.1 (2.7 KiB, 1,317 hits)

He not only improved the software but also change some hardware design to make a better reading effect.

Above is a door controller which made by Flemming Frandsen :
  • ATmega168 (easier to get than ATmega328, but with less EEPROM)
  • Ethernet controller (ENC28J60) + RJ45 transformer
  • 8 KB IIC EEPROM
  • 12V / 3 A switch mode buck converter (passive PoE 15-30 V)
  • 3.3V / 800 mA linear regulator (fed by 12V)
  • 2x 10A relay outputs with an indicator LED
  • 3x RJ45 connector (with LEDs) for Keyboard, RFID and lock
  • Protection Diodes to GND and 3v3 ,all GPIO pins brought out to the RJ45 connector
  • Standard 6 pin ICSP header
  • 6 pin FTDI header
  • 6 pin serial IIC + power header

You can find the RFID which basis on Sniffer Nano, but Flemming Frandsen made some change on it to get a better reading effect :

  • The DC-blocking C3 capacitor has been changed to 100nF.
  • The amplifier got a higher gain and a 1 nF capacitor in the
  • Inverting feedback to cut down on the carrier wave.

The Schmitt trigger was changed out completely to a traditional coupling, but with an automatic threshold voltage via an RC filter.

Download the whole schematic of this door controller here:

  Door Controller schematic (115.5 KiB, 1,003 hits)

You can get more detailed information about this door controller on Flemming Frandsen’s site:

http://dren.dk

If you can read the Danish, join this post: http://www.hackaarhus.dk/forum/viewtopic.php?f=4&t=90