Before maker faire 2014 commences, we finished version ITEAD OS 2.0BETA of A10 and A20 versions and upgraded the original ITEAD OS SDK. The new codes have been updated to github HERE. In order to validate and demonstrate SDK, we … Continue reading →

As we mentioned before , IBOX can run various versions of operating systems, including linux and android , etc. Some guys are wondering about the differences between the operating system of FLASH version and SD card version, thus we’d like … Continue reading →

Under normal circumstances, when you want to compile your own customized system, you can compile manually from the source codes step by step, which costs you a lot of time and efforts. Fortunately, experts on linux-sunxi prepared a nice compiling … Continue reading →

As we mentioned in the previous blog "ITEAD OS And SDK Introduction", we customized a linux system for Iteaduino Plus A10, and the various branches of properties are to facilitate developers and DIY users for rapid prototyping developments with Iteaduino … Continue reading →

Recently we launched a board Arduino Plug for Iteaduino Plus, which breaks out SPI, IIC and UART interfaces on Iteaduino Plus to one Arduino-compatible interface and another compatible with Xbee. There is an OLED screen on the shield that can be … Continue reading →

In the previous blog, we made a brief introduction to structure and function of ITEAD OS and SDK, and now we want to experience how to use SDK API to realize display function of OLED screen on Iteaduino Plus. To … Continue reading →

Originally we planned to release the official version of ITEAD OS and SDK in November. However, due to some technical reasons, it must be put off. As we rescheduled, we will release ITEAD OS with GPIO, UART, IIC and SPI … Continue reading →

Iteaduino Plus is an open-source ARM development board, which is based on Allwinner A10 SoC, small size, hacker friendly, extendable and very low-cost. Itead customized IteadOS, an operating system based on Ubuntu for it, offers operation function of the underlying hardware … Continue reading →

Here I would like to share with you how to install the protective case for Iteaduino Plus. Please follow the following steps: 1, Put the short bolt through the hole on baseboard, and then screw the long bolt on it. 2, … Continue reading →

In some applications, you may want to have a relatively fixed IP address for Iteaduino Plus. However, there is no fixed MAC address for Iteaduino Plus, as it is randomly assigned by the system each time when booting, while no … Continue reading →