Loading...

You have no items in your shopping cart.

 
 
 
×

Registration

Profile Informations

Login Datas

or login

First name is required!
Last name is required!
First name is not valid!
Last name is not valid!
This is not an email address!
Email address is required!
This email is already registered!
Password is required!
Enter a valid password!
Please enter 6 or more characters!
Please enter 16 or less characters!
Passwords are not same!
Terms and Conditions are required!
Email or Password is wrong!
Captcha is required!
Captcha is wrong!

Upload Program To Arduino With BT Shield

The BT shield v2.2 use the same Bluetooth module as Iteaduino BT, we can hack it and make it a wireless programmer for Arduino as well. Here we take a Iteaduino with BT shield as a example, to show you how to upload the program to Arduino via Bluetooth.

1. Welding a 1uF capacitor between Pin32 of HC-05 module and the Rest pin of BT shield.

2. Set the jumpers on BT Shield: D0 with TX, D1 with RX. Set the mode switch of operation mode to CMD side.

3. Connect the Iteaduino with PC via USB cable, and open the “AccessPort” software:
– Choose the right COM number
– Change the baud rate to 38400

4. Send the AT command to change some configurations of the HC-05 module:
AT+ORGL (Restore the default state)
AT+ROLE=0 (Configure the HC-05 as slave)
AT+POLAR=1,0 (The LED will on when the output of PIO8 is high. And it indicates connecting successfully when the output of PIO9 is low.)
AT+UART=57600,0,0 (Set baud rate to 57600, one stop bit and no parity bit)
AT+INIT (Initializing SPP library)

5. Download Arduino IDE. ( don’t use the Arduino 00xx )  Download the “rxtxserial.dll” file here, and replace the one in your Arduino IDE  Folder.

6. Disconnect the Iteaduino with PC, and reset the jumpers: D0 with RX and D1 with TX. Put the mode switch to DAT side.

7. Repower the Iteaduino, and use the laptop or PC to search the BT shield (if your PC doesn’t support Bluetooth, we recommend this Tiny USB Bluetooth Adapter )

8. Enter pin code “1234” and connect to the BT shield. Check the COM number of the serial Bluetooth port (When you check in Hardware Device Manager, it will show you 2 ports , and just one can be used for wireless programming)

9. Open Arduino IDE. You should select “Tools->Board->Arduino Duemilanove w/ATmega 328″. And select “Tools->Serial Port->COMX (the serial port of the Bluetooth device)”.

10. Press the “Upload” button, the program will be upload into Iteaduino by Bluetooth !

Note: This is an example for Iteaduino (Arduino Duemilanove), if you are using the Iteaduino UNO (Arduino UNO), there are some different:
  • Using the AT+UART=115200,0,0 but not the 57600 now
  • Choose the “Arduino UNO” instead of the “Arduino Duemilanove w/ATmega 328”

More step by step tutorials, you can find it here <Wireless Programming Your Iteaduino BT>.