Loading...

You have no items in your shopping cart.

Currency
 
 
 
×

Registration

Profile Informations

Login Datas

or login

First name is required!
Last name is required!
First name is not valid!
Last name is not valid!
This is not an email address!
Email address is required!
This email is already registered!
Password is required!
Enter a valid password!
Please enter 6 or more characters!
Please enter 16 or less characters!
Passwords are not same!
Terms and Conditions are required!
Email or Password is wrong!
Captcha is required!
Captcha is wrong!

Review Details

ITEAD Dual Step Motor Driver Shield Expansion Board Kit for Arduino - Red

ITEAD Dual Step Motor Driver Shield Expansion Board Kit for Arduino - Red

Product Review (submitted on January 14, 2015):
This board works great in the full step mode. Unfortunately I found a problem with the current limit and micro stepping features. The current sense resistors on the card are the wrong value. Without a current sense resistor, you would not have the internal constant current control function. Since micro-stepping is based on controlling/stepping to different current levels, it would not properly micro-step. You may also possibly exceed the current rating of the driver depending on motor supply voltage and motor winding resistance. This could cause damage or failure to the driver. If you really need accurate micro-stepping be prepared to replace the 0 ohm sense resistors with 0.75 ohm or greater resistors. These are R3, R4, R7 and R8 on the shield.